The picture of the FRPsheeting overlap joint

Release time:

2024-09-05

The general corrugated plate lap joint:The FRP sheeting directly button in the profiled sheet all around,paste the check water tape at the lap joint place of the steel side.

I.The lap joint of Single-neck FRP sheeting and profiled sheet
1. The general corrugated plate lap joint:The FRP sheeting directly button in the profiled sheet all around,paste the check water tape at the lap joint place of the steel side.Put on the purlin when lap joint the same direction with the length, overlap over 250mm with the colour plate,at the same time paste two 2*200mm check water taps at the set up sides.

2. Homologous lap joint lll steel sheet:jiaochi hidden discount type FRP sheeting is introduced touse the ramrod davlighting from the ridge to the eave.lf must use dot mode daylighting,need to dothe cutting processing at the place close to the roof and the FRP lap joint.And need to add thewaterproof closing edge or other waterproofing dispose.

Note:FRP lap joint please consult the technical section.
3. The first processing scheme of the 180°/360° vertical seam hemming profiled steel sheet:Thetrough type light plate add cloding edge will be the same with the lap ioint of the color plate.Aftepasting the check water tvpe between waterproof closing edae and the FRP sheeting.use thespecialized waterproof aluminum blind rivet to fixation.(Remark:jiaochi 2 type like HV475etc canalso refer to the picture.

4. The second processing scheme of 180° /360° vertical lock seam of profiled sheet sheet is:installsimple and convinent,the handle of waterproofing is simple and with an impressive effect,wholeeffect is beautiful.lt is suitable to dot mode and poker etc kinds of lapping way.

II. Double FRP sheeting lap node diagram
1. The processing scheme of the sandwich insulation steel plate double plates.

a. TD760 and Q900 lap joint sketch map:lt is similar to the double FRP sheeting that lap joint with the sandwich steel plate,need to add Z type holder between the double FRP sheetings.

b. The processing scheme of the FRP sheeting which distributes above and below the purlins:The above FRP sheeting which add closing edge is the same with the lap joint of the two plates FRF sheeting.Double separating style,air is the insulating medium,can reduce the happen of conden.sate phenomenon

c. This processing scheme is for double sheet put above the purlin,in the middle add the insulated cotton or time purlin.

2、 The processing scheme of FRP sheeting corresponding to the high strength aluminum foil coverinsulated cotton single steel sheet roofing.

a. SS468 double sheeting with closing edge picture:Two sides FRP sheeting with closing edge,theair in the middle to be as Iinsulation layer,use PE foam plug to seal at the two sides.

b、The overlap joint sketch map of LS025 double FRP sheeting

III.Concrete roof FRP sheeting lap joint sketch map

IV.The FRP wall space lap diagram
a. The wall FRP sheeting use the generally corrugated plate,it is easy to lap joint and waterproofinghandle.And can lavout as the clients demand,the lengthwise direction lap joint overlap part is noless than 200mm.

b、The sketch map of making the high position window of the wall

V. FRP sheeting acr lap

The LS838 FRP sheeting which produced by our company,the crest height is 16mm,the minimumbending radius can reach to 2m,can use widely in the arc-shaped roof construction.LS838 FRP shee, the strength is higher than the low crest FRP and the slab.it is waterproof and easy tohandle.And it has a beautiful effect.